Install eufy Permanent Outdoor Lights E22 100ft Guide

Quick Answer

To install the eufy Permanent Outdoor Lights E22 100ft kit, mount the track under your eaves, connect the power supply, and use the eufy Security app to complete the setup. The process takes about 2-4 hours for a typical home.

Installation Steps

1. Plan Your Layout: Measure your eaves or soffit where you want to mount the lights. The 100ft strip can be cut at marked intervals (usually every 3 feet) to fit your roofline. Plan the path from the power outlet to the farthest point, ensuring the control box stays within 5 feet of an outlet. Common mistake: cutting the strip at a non-marked point will damage the circuit. Only cut at the designated cut marks.
2. Mount the Track: Hold the mounting track against the eave and mark screw holes every 12-18 inches. Drill pilot holes and screw the track into place. For corners, use the included corner connectors. Ensure the track is level; a slight tilt can cause water pooling. Checkpoint: use a level on every section. Uneven mounting creates visible light gaps when the strip is installed.
3. Insert the Light Strip: Peel the backing from the light strip and press it firmly into the track channel. At cut points, use the included end caps to seal the open end. For corners, connect strip sections with the corner connectors, ensuring the arrow markings align. Common mistake: forcing the strip into corners without using the corner connector can bend the LEDs and create hot spots.
4. Connect the Power: Plug the control box into the power adapter, then connect the control box to the light strip using the included cable. Plug the adapter into a weather-protected outdoor outlet. The lights should briefly flash to indicate power. Checkpoint: if the lights don't flash, check the connection between the control box and the strip. A loose connection is the most common power issue.
5. Set Up in the App: Open the eufy Security app and add the device. Follow the in-app prompts to connect the control box to your 2.4 GHz Wi-Fi network. Once connected, you can adjust brightness, color, and schedule the lights. The AI-powered lighting feature requires you to enable it in the settings. Common mistake: the app may not find the device if your phone is on a 5 GHz network. Temporarily switch to 2.4 GHz during setup.
6. Test and Adjust: Walk around your property to check the light coverage. Use the app to adjust brightness and color temperature for each zone. For the AI feature, set your preferred schedule and let the system learn your patterns over a few days. Checkpoint: if a section of the strip is dimmer than others, it may indicate a bad connection at a cut point. Recheck the end cap or corner connector.

Product Details

• eufy Permanent Outdoor Lights E22 (100 ft, Black): The lights incorporate a triple-LED design, combining RGB, warm, and cool white LEDs, providing up to 90 lumens and adjustable color temperature from 1500K to 9000K. This means you can create warm accent lighting for cozy evenings or bright cool white for security purposes, all from the same strip.