Fragrance Refill for eufy Omni S2: Bamboo & Sage Care Guide
By eufy - Built with Care | Home Security System & Robovacs | Published: 2026-10-16
Category: Tips og pleje
Keep your Omni S2 smelling fresh with the Bamboo & Sage fragrance refill. Learn how to install, replace, and care for the cartridge so every clean leaves a light, natural scent.
Quick answer
Replace the fragrance refill in your eufy Omni S2 every three months, or sooner if the scent fades. The Bamboo & Sage refill installs in seconds: lift the magnetic top cover, remove the protective sticker, and place the cartridge inside. No tools are needed.
What the Bamboo & Sage refill does for your Omni S2
The Fragrance Refill for Robot Vacuum Omni S2 (Bamboo & Sage) is designed specifically for the Omni S2. As the robot cleans, it releases a light bamboo and sage scent, so your home smells fresh after each run. The refill is not a cleaner or disinfectant—it simply adds a pleasant aroma. If you prefer a fragrance-free clean, you can leave the cartridge out without affecting the vacuum's performance.
When to replace the cartridge
eufy recommends replacing the fragrance refill every three months, depending on how often you run the vacuum. If you clean daily, you may notice the scent weakening after eight to ten weeks. A simple check: after a cleaning cycle, if you can't detect the bamboo and sage scent in the room, it's time for a new cartridge.
How to install the refill: step by step
Installation is tool-free and takes less than a minute. Follow these steps to ensure the cartridge sits correctly and releases scent evenly.
Step-by-step: replacing the Omni S2 fragrance refill
- Power down and open the magnetic top cover: Turn off the Omni S2 and lift the magnetic top cover. The cover is held by magnets, so it pops off easily without force. Common mistake: forcing the cover. If it resists, check for debris around the edges.
- Remove the old cartridge and protective sticker: Take out the spent fragrance refill. If you're installing a new one, peel off the protective sticker covering the scent vents. Checkpoint: the sticker must be fully removed or no scent will be released.
- Place the new refill inside the compartment: Set the Bamboo & Sage refill into the designated slot. It should sit flat and secure—no adhesive or tools needed. Common mistake: inserting the refill upside down. The scent vents should face upward.
- Close the cover and run a test cycle: Snap the magnetic cover back into place. Run a short cleaning cycle and check for a light bamboo and sage scent. If you don't notice a scent, confirm the sticker is removed and the refill is seated correctly.
Product facts
- Fragrance Refill for Robot Vacuum Omni S2 (Bamboo & Sage): Model Compatibility: Compatible with eufy Robot Vacuum Omni S2. Confirms this refill fits your Omni S2 without adapters or modifications.
- Fragrance Refill for Robot Vacuum Omni S2 (Bamboo & Sage): Suggested Replacement Frequency: We recommend replacing every 3 months, depending on your usage frequency. Sets a clear maintenance schedule so you can plan replacements and avoid scent fade.
- Fragrance Refill for Robot Vacuum Omni S2 (Bamboo & Sage): Tool-Free Installation: Open the robot's magnetic top cover, remove the protective sticker from the fragrance, and place it inside the machine. No tools required—you can swap the refill in under a minute.
